PrusaSlicer & SuperSlicer¶
The recommended slicer for the My-Cloner Rev A is OrcaSlicer.
PrusaSlicer and SuperSlicer can be configured for a Klipper printer, but official validated My-Cloner Rev A profile bundles for these slicers are not currently published.
Current Project Position¶
The Rev A release work is focused on:
- A validated My-Cloner machine definition
- OrcaSlicer printer settings
- Tested filament and process profiles
- Klipper / Mainsail workflow
Do not import profile bundles from older My-Cloner prototypes or unrelated MK3/MK3S configurations and assume that they are compatible.
Using Another Slicer¶
If you choose to configure PrusaSlicer or SuperSlicer manually, the machine definition must agree with the validated My-Cloner Rev A configuration, including:
- Build volume: 230 × 230 × 220 mm
- 0.4 mm standard nozzle
- Klipper-compatible G-code workflow
- Current motion limits
- Current start/end G-code or macros
- Validated material settings
Motion limits, machine G-code and other firmware-dependent values must not be copied from a legacy printer profile before the final Rev A Klipper configuration has been validated.
G-Code Transfer¶
Generated G-code can be exported from the slicer and uploaded to Mainsail.
Always review the sliced file before printing and never run G-code prepared for a different machine unless its compatibility has been verified.
Related Documentation¶
For the recommended slicer:
For the current public-profile status: