Skip to content

Downloads

📦 Download the files required to build, configure and maintain the My-Cloner Rev A.

This section contains the official downloadable files for the My-Cloner Rev A.

Use files that belong to the same hardware revision whenever possible. Mixing files from older prototypes or different revisions may cause mechanical, electrical or software incompatibilities.

Available Downloads

  • Bill of Materials

    Download the complete revision-controlled BOM in XLSX or CSV format.

    Bill of Materials

  • STL Files

    Download the printable parts required to build the My-Cloner.

    STL Files

  • CAD Files

    Access the available 3D and 2D engineering files for the project.

    CAD Files

  • Firmware Configuration

    Download the Klipper configuration and related printer firmware files.

    Firmware Configuration

  • Slicer Profiles

    Download the recommended OrcaSlicer profiles for the My-Cloner.

    Slicer Profiles

  • Offline Manual

    Download an offline version of the My-Cloner documentation when available.

    Offline Manual

Open Tools, Open Files

You do not need proprietary or paid software to access the My-Cloner project files.

Free and open-source tools can be used for the main file formats provided in this project:

Use the Tools You Prefer

These applications are suggestions, not requirements.

The goal is to keep the project files accessible through open and widely supported formats, allowing you to choose the tools that best fit your workflow.

Hardware Revision

The files in this section apply to:

My-Cloner — Hardware Rev A

Before downloading or manufacturing parts, verify that the file belongs to the hardware revision you are building.

Future revisions may introduce changes to:

  • Mechanical parts
  • Printed parts
  • Electronics
  • Wiring
  • Firmware
  • Slicer profiles

For a new build:

  1. Download and review the Bill of Materials.
  2. Obtain the required mechanical and electronic components.
  3. Download and print the required STL Files.
  4. Use the CAD Files when manufacturing custom components.
  5. Follow the Assembly Guide.
  6. Complete the electrical installation using the Wiring & Electronics documentation.
  7. Install the Firmware Configuration.
  8. Configure the recommended Slicer Profiles.

Do Not Mix Revisions

Files from different hardware revisions may look similar while having important dimensional, electrical or configuration differences.

Always use a consistent set of files for the same My-Cloner hardware revision.