Firmware Configuration¶
The firmware configuration for the My-Cloner Rev A is still under development.
The planned software architecture is based on:
- Klipper
- Raspberry Pi Zero 2 W
- MKS Robin Nano V3
- Mainsail
The final configuration will include the required Klipper files, including the printer configuration used by the My-Cloner Rev A.
Not Yet Available
The official My-Cloner Rev A Klipper configuration is not yet available for download.
This includes the final printer.cfg and the complete Raspberry Pi / Klipper setup required for the printer.
Planned Downloads¶
This page will later provide:
- My-Cloner Rev A
printer.cfg - Klipper configuration files
- Raspberry Pi setup instructions
- Mainsail configuration guidance
- MCU firmware information for the MKS Robin Nano V3
- Required macros and machine-specific settings
Important¶
Do not use configuration files from older My-Cloner prototypes, MK3S-based projects or unrelated printers.
The final configuration must match the actual My-Cloner Rev A hardware, including:
- Mainboard
- Motor configuration
- Probe
- Thermistors
- Heaters
- Fans
- Endstop or sensor configuration
- Build volume
- Motion limits
Coming Later
This section will be completed once the Raspberry Pi, Klipper installation and final printer.cfg have been tested on the My-Cloner Rev A.
Related Documentation¶
For the current hardware specification:
For slicer configuration:
For the printer setup process:
Current Installation Plan¶
The owner confirms an MKS Robin Nano V3.0 and Raspberry Pi Zero 2 W, with microSD card and reader available. A clean Klipper/Mainsail installation is planned. The previous printer.cfg is unavailable, so the configuration must be created from scratch. No configuration is supplied or validated by this documentation update.
Use the confirmed hardware record as the starting point. Motion limits, probe offsets and polarity, sensorless thresholds, motor operating currents, bed sensor_type, PID and extrusion calibration remain pending.